• Hello MLAers! We've re-enabled auto-approval for accounts. If you are still waiting on account approval, please check this thread for more information.

Search results

  1. Y

    Local Talk ?

    I have precisely the cable linked in the first post and was able to connect two SE/30s running 6.0.8 and 7.0.1 directly through localtalk. I was unable to connect a Classic running 6.0.8, an SE running 7.0.1, or a Quadra 700 running 7.6.1 to either SE/30 or each other in any combination. Are...
  2. Y

    Recapped SE/30 with no Speaker Sound

    I resoldered every joint for the harness and PSU connector at once so I can't say for sure, but it was most likely the -12v pin on the harness. The joints looked perfect before resoldering them, so don't rely on visual inspection alone!
  3. Y

    Recapped SE/30 with no Speaker Sound

    UPDATE: It turned out to be a faulty joint on the analog board. After resoldering all joints for the PSU and logic board connectors, sound has been restored.
  4. Y

    Recapped SE/30 with no Speaker Sound

    Thanks for the advice. The two springloaded metal bars in the headphones socket both return to their home position when the jack is unplugged. Was dried grease interfering with the connection in yours, falen, or were the bars not moving at all?
  5. Y

    Recapped SE/30 with no Speaker Sound

    capacitor in question:
  6. Y

    Recapped SE/30 with no Speaker Sound

    Two questions regarding a recently recapped SE/30: 1. The internal speaker does not emit sound even after cleaning the logic board and recapping all capacitors. I've swapped speakers and checked that all power cables are properly attached. The audio out jack works, producing loud, clear sound...
  7. Y

    SE/30 Blinking Question Mark Floppy only on Cold Boot

    It is a 1988 Quantum. I'm guessing the rubber bump issue is a problem that can only be resolved by replacing the drive?
  8. Y

    SE/30 Blinking Question Mark Floppy only on Cold Boot

    I should add: disk repair finds no errors and the disk was recently re-initialized and reformatted with a clean install of system 6.
  9. Y

    SE/30 Blinking Question Mark Floppy only on Cold Boot

    I recently recapped an SE/30; all appears well except for one oddity. On a cold boot, no system is detected and the blinking question mark floppy is displayed. If the computer is immediately reset at the power switch, the system is found on the hard disk and boots without fail. Restarting from...
  10. Y

    Clean Up Window/Selection under System 6.0.8

    Is there an extension or utility to improve the Special->Clean Up command under system 6? Specifically, I'm looking for something which correctly spaces icons and folders depending on length so filenames do not overlap or move outside current window borders.
Back
Top