Search results

What's the admin key for the installed AppleShare Pro Admin?

I found that if I unchecked "Enable Unit Attention" and "Disable glitch filter" it started working.  On my other SCSI2SD card with the install I did from scratch those are both checked.

I did have Lido so I tried it.  It could see both disks on the SCSI2SD card but when I tried to mount the one at ID 0 the light flashed for a few seconds on the card and then everything hung.  I could still move the mouse but that's about it. When I insert the SD card in my MacBook Pro it is...

I'm back to this after my SE/30 died.  It's not repaired but I picked up a Quadra 700.  It boots just fine from an SD2SCSI card that I installed A/UX on before.  I've tried to get this installed again and I get the error 21 even after following the steps.  It looks like giving the LaCie...

I had found an old thread that said a normal SE/30 only had to have one bank populated when using 16MB SIMMs unless you had an accelerator.  I decided to test it with four 1MB SIMMs in the second bank and it worked.  So it looks like a variation on standard SE/30s as some work and some don't.

I have an SE/30 with eight 16M SIMMs.  I've been using it with A/UX.  I wanted to try the prebuilt A/UX image with my SCSI2SD card but I get a Sad Mac error when I try to boot it.  I tried the troubleshooting steps in that thread in the *NIX forum without luck so I decided to try to remove half...

I'm trying to use this image on an SE/30.  The SE/30 has 128MB of RAM.  When I start up I get the Sad Mac 000021 error.  I've tried the troubleshooting steps including the recommended forcing of SCSI ID 0 followed by 1 and haven't had any luck.  Does anyone have any ideas where to look next?