Search results

Thanks ! I didn't have a blank bracket around but that's a good idea ! The "someone" is me. Don't bother, I found the resistors values. I did this project using your previous pictures, so thanks a lot !

@Mr. Ksoft thank you that did it. It does indeed sounds like the stock game

Some measurements and subjective remarks. This has been benchmarked against a Quadra 650 board (Wombat). I did it to double check something wasn't broken with the daughter board Output levels The last notch on the PAS16 Control Panel volume is an overdrive, 100% volume is last position minus...

Nope, not any better 😕

Thanks a lot ! I would keep the box, the card is more valuable this way, but you do you :) The gerbers files and design has been released on GitHub here Will try to release the measurements this week-end as well

How do you use the image file ? I've been trying with DiskCopy but it doesn't like it (because no ressource fork I guess)

Build log First remove bracket. Then desolder C101, C110 and the HD26 connector In my case C101 was dead, the card needed a recap anyway Assembling the daughter board This requires soldering all three jacks, both Molex connectors and both capacitors. Everything CMS can be assembled by your...

Unfortunately no, not enough room

As promised on the NUBUSPAS16-DB thread, here are my notes Connector Incomplete connector pinout, card side __________________________________ \ / \ 09 08 07 06 05 04 03 02 01 / O \ 18 17 16 15 14 13 12 11 10 / O \ 26 25 24 23 22 21 20 19 /...

Introduction pitch A member of the forum gave me this card (without the matching breakout box) for R&D purposes. Sometimes R&D gives birth to something so here we are. The initial design for a breakout box was plagued with a few issues, like missing information about some custom chips and lack...

Can you upload that copy somewhere so I can test it there ?

@Phipli No worries I 100% agree with what you said. @croissantking just R&D, sorting stuff from the TODO list :). I kinda want to use another MCU in SPI slave mode and communicate with it from within MacOS. Hardware side is doable, software side we do not have any idea where to start...

Good job ! I still need to find some motivation to do mine. I will grab the cable you used

Thank you for this. I read a few of the files but no motion of SPI. the first file is similar to what you can read in "designing cards and drivers for the macintosh family third edition" I'm assuming the Express Modem is the one using it. On the Express modem dev kit, everything point to using...