Search results

The adapter is now finally up on Tindie.

The link femu-231209M leads to an page not found error. Update: Now saw the new link, thanks!

My Classic II has a recapped logic board and a known working analog board. Voltage measured on the floppy port is stable 4.98V and 11.95V. The Mac powers up when switched on (fan, disk spinning) but not boot chime. After two to three minutes, it suddenly chimes and works flawlessly. Any...

Update: I found it. It’s R6 and the via connecting to it is just above the defective cap‘s pad.

Did you ever retry to fix the Classic II? I'm curious to know as I have a similar issue with mine.

I'll post a link to my Tindie store next weekend. It'll make it easier to order the parts. Stay tuned.

The + pad of the C6 capacitor came off. I checked the logic board schematics and noticed it would connect to a resistor. However, that resistor does not have a lable. Does anyone know where the pad would connect to? Source: Macintosh Classic II Schematic (bomarc).pdf - Chris

I have some on stock as well for A3 users in Europe.

I have this module that I bought on ebay "tested and working" with 128MB RAM in a PB 3400. Does anyone know why it only shows 64MB?

Just curious: What are alternatives in Europe?

A BlueSCSI might give you a more seamless experience.

What options are out there to fix a broken joint on the lower left CD drive cover?

The link to "Clock Chipping page" doesn't seem to work. Can you repost it?

Some of the screws are under the rubber. You'll probably feel them then you push the rubber a bit. Their position is the same as with the P6500 PSU. Note the additional two screws holding the transformer in the TAM PSU but you won't need to loosen them to remove the case.

They are built on the same basis, however, they are different in details. You'll finde a nice write-up over at Tinkerdifferent.

It is alive! Just realized that I forgot to connect one plug in the PSU. Thank you all provided here in this thread. In summary, the overvoltage caused the MOV and TOP200 to fail. I sourced these parts from a DPS-150GB B PSU for a Performa 64/6500. Once these were replaced, the TAM works flawlessly.

Ok, so I switched the TOP200. No success. Coming back to the task to measure the voltage of the yellow wires: Which one of the following table do we want to measure? Pin Connector Label 1 J2 Pin 7 AMP OE 2 — — 3 J2 Pin 14 AMP RHS 4 — — 5 J2 Pin 10 SPKR RHS 6 J2 Pin 9 SPKR...

Could you point me to the location on the board where I could find the TOP226Y? I found a few similar ones but not this particular part:

I couldn't see any labels, unfortunately. Looking at it again, I now see three yellow cables. Two with similar diameter and one with a thinner wire.

Yes, the fuse was replaced and working. There are two yellow wires. Which one do you mean?