Search results

I had the some problem with a 7000 in a 9500 with a sonnet crescendo card, I gave up. ATI drivers made the computer crash or having odd behavior. To make things harder, french ATI extensions and english ATI have different names, you should mess with extensions to avoid mix-matchs.

Congrats on getting your Portable almost back to working! Did you deeply cleaned your motherboard ? Sometimes capacitor goo goes under chips and may cause problems. Also check the lead acid battery voltage shoud be above 6V by a good margin or it will be considered low battery and the portable...

Those locks are cheap, and probably difficult to re-key. The lock should have a tag consisting of 3 numbers on the cord, this is the key number, it can in theory be used to make a new key.

Some of us have a Levco accelerator which does use on board RAM and accelerator RAM. On board RAM is used as RAM disk only if I’m not mistaken, because it is slower than the one used by the accelerator. This accelerator use a ROM and GALs to patch the macintosh ROM, we dumped the first but...

Disk Setup is only able to deal with disk attached to SCSI and IDE internal controllers. I don’t recall being able to deal with FW, not able to deal with USB for sure. Also don’t do low level format on flash based device, it just wear the card, not dramatic but not a good practice. Anyway...

No happy Mac or Mac OS refusing to boot because not a CD? With which Mac OS have you formatted the drive? On OS X, Apple extended may not work, if you can format from a computer that support HFS (non plus) as formating with HFS+ may produce different outcome depending on your OS version. On...

What do you mean by burn? Because if you byte-copie the CD image to the CF you’ll run into problems as CDs have a different Apple Driver from hard drives. To have a working CF you must format it in HFS with a proper Apple partition map and driver first. Then you can try to copy the CD files to...

This is bad but possibly not unfixable, but quite difficult if you are not experienced. There might be broken pads and few cms parts to replace. I would recommend you to cut this wire nest the closest to the board, taking extra care to not tear it from the motherboard to avoid more damage...

That was quite an amount back in the day, you also have to consider memory cards where expensive not been a standard format didn’t help. For reference the iMac G3 was shipped with « only » 32MB in 1998. 48MB is plenty of memory for 8.6, you’ll be fine here. Depending on what you do virtual...

It depends on the model, could be 117, 133 or 166. (Edit: nwm you asked for LaPorta’s PB I guess, 8.x works fine on any of these speeds) You want at least 32MB for 8.x even it technicaly requires only 16MB with Virtual Memory enabled.

I had really strange behavior with disks (floppies or cds) on a 6100 with 8.5, I wouldn’t trust it without the 8.5.1 or 8.6 update. (Free updates) Same for 8.0, I have seen some Macs just crash without the 8.1 update. So that might highly be OS related. Another strange case is my Powerbook G3...

As I mentioned it’s probably not the adapter itself, but the CF card that don’t play well with the IDE controller. I used the some adapter board in my 3200 and it went well, but I used an industrial card. Using SD to IDE is fine but be sure to get a good quality SD card, even if the adapter...

Almost all SD to IDE adapters like the one above are actually SD to CF adapters (CompactFlash has an IDE mode) They use the same chip and are limited to 25 MB/s transfert rates due to the protocol supported. IDE/Sata don’t play nice with pre-G3 machines due to adapters having only ATA-66 (or...

Hello, I recently refurbished a Quadra 900 PSU, it had bad capacitors, mostly due to bad storage, all electrolytes replaced with the proper part. Previous recap with the same BOM when fine on a previous Quadra 950 but this just won't stay up. At first the Quadra 900 wouldn't power on, I though...

The 4400 should be able to power the card just fine, it is designed to handle the most power hungry PC cards and the 100MHz is not one of these, but I found its PSU to be way cheaper than the other Power Macintoshes. Mine is due for a recap soon or later, I’m not surprised yours started failing...

Hello, Head alignment is a bit different (it’s about how the head is oriented), you have dealt with track alignment which is fastidious but easier. I made this mistake few times, some drives can’t be disassembled without messing with the zero track detector, I did clean my 6100 floppy drive...

Hi, it’s not related to the CPU as every powerbook supports it and the famous Portable. It’s related to hardware support, more precisely support in ROM. It’s described in TIL9334, I didn’t found a link to it yet sorry.

You can’t browse the site you must have direct links to the files and some parts have been removed a while ago. There is a lot of localized software still available, german having a fair amount of files.

Yes they are as they are subdomains from apple.com I posted a list of potentially still working urls here: https://68kmla.org/bb/index.php?threads/download-info-curated-link-list.48044/