Search results

Thanks again for advice. Yes, it is a WD drive... I'll try the old 4GB next... No, I did not zap PRAM again - I had one that prior to installing a fresh OS9.2 and Panther... I'll post an update on pragress as soon as time allows - probably during the weekend. I have tinkered with several old...

Last night I followed Drew's suggestions: removed all PCI cards except for the ATI graphics, and connected the partitioned hard disk to the internal bus. Clicked on XPostfacto, and asked the computer to start installing Panther. It rebooted nicely, and installed the OS until completion. Great...

Thanks again! No, I did not see "panic -we are hanging in here". I remember it said something about BOOT, and BYE - both were OK'd, and then finally there was a prompt of some kind. Nothing more happened and I pulled the plug after 5 minutes... I will try installing with the drive connected to...

Thanks again for the responses. RAM: 640MB (2x 256, 1x 128), pulled from a B&W rev1 that suddenly died when its hard disk crasched due to mechanical failure; I assume the motherboard is gone as not even pressing the CUDA switch helps... Did I leave the new hard disk set on SLAVE?. No. It...

Many thanks to all of you that answered my question. Yes, the G3 Beige motherboard worked after moving the jumper. I am still struggling with the computer - the old G3s have a lot of idiosyncracies... I want it to run Tiger... It was a struggle to get it to start up on a 125 GB IDE HD connected...

Thnaks for the information. Drew, where is the jumper? On the power supply or the motherboard? I have not been able to find it! Where can I find the pin out for these power supplies? I have spent hours with Google, but failed sofar.

Is there a difference between the beige Tower and DT G3 power supply pin outs? I recently got for free non-functioning a beige G3 tower with a 333MHz processor, plenty of RAM, and a SCSI-3 hard disk connected via an ATTO SCSI card. I got it to start up fine on an old external SCSI HD with OS9 I...