Search results

I am posting in this forum to see if anyone here with an non working apple iie or parts would happen to have a few extra memory chips, aka 16 pin dip memory chips from one of their memory expansion boards? The chips are also the same used on the original mac 128k and I have a bad chip I need to...

Hello I was wondering if anyone has any knowledge in regards to an older application called Fullpaint. I recently obtained a disk that someone had copied this application onto. However whenever you try to run the application, whether from disk or hard drive, you get the following message...

Excellent I have been to this site but did not realize they had all the part numbers listed. My disk is a 690-5011-C, which according to the site was made for the 512k. The disk should contain macpaint 1.4 and system 1.1g. Which is good I have that software on a macterminal disk. Thank you

Hello I have an original Macpaint disk. I acquired it but it does not seem to be recognized in my 512k or plus or SE machines. I have cleaned the disk drives so I know they can read other 400k and 800k disks ok. I have several questions, want were the contents of the original macpaint disk...

Was this the one the guy had listed in upper arlington for 20 bucks? I noticed the post is gone. I noticed someone had a free g3 aio last week, I think the person who got it put it on the curb because I saw another one listed not far away a few days later. I think the person who got the g3...

I got a 7300 from a local ad today. Case was a little beaten up, the tabs to push on to slide the cover off were completely gone, so the case no longer locks closed. I had to reattach the rubber feet and glew the case prop open black stick thing together. However to my delight it had the...

Only if you don't see a VRM in all the available VRM sockets, for that system I believe there should be 2 but the ref guide should steer you accordingly. On their website if you go to the support section, make sure you have the MN: xxxx-xxx (located on the small sticker on the front or back)...

The speed of the processors have to match and they have to be P3s, I don't beleive that celerons are officially supported in dual configs. Officially you are "supposed" to use the same stepping models, but I have found some systems where you don't have to. ECC is not always required, however...