Search results

Good luck with it. Unfortunately I ordered one of these panels a couple of days ago So I'm hoping you sort it out before I attempt to change mine. Cheers

I see I'll have to try mine again felt sure it worked?

Can't you just connect display directly to 30video thats how I do it?

@shirsch did you ever try the scaler on a plus or 512k as per my previous post #89 about poor quality result?

Did you actually remove the chips you have reflowed? It will be dirty and possibly have track corrosion under them

It sounds like the analogue board is dead from what you have described. Currently have one SE DV with same problem and have replaced the analogue board wit SE 600 mhz one as couldn't find a 700 mhz board

I can see green grunge and dirt. Ultrasonic clean an see what happens. If no go you will need to lift a few chips and see what it's like under them

I had a pb100 that was repaired by an Apple repairer a long time ago and they used a coloured silicon in the holes. I discovered this many years later when working on the pb. The silicon had set and looked like the original covers.

Why not. I still cant get a decent image from the 300A

RP7 quite possible its dead. Can you boot it from floppy?. If so may be scsi chip is dead as well

I'd send it back to Will. Have you tried the original ROM sim? Did you wash in isopropyl after ultrasonic and leave it a couple of days to ensure it was fully dry? Check what pin 7 and 8 on the 68882 do, quiet likely shorting would affect it and other chips

Any recommended suppliers?

Old thread but I have this problem with no boot from 7.5.3 and I have tried the resedit fix to no avail???

Zebra lines is what you get without the ROM sim. Are you sure the sim is OK?

Also check all the pins and the socket for corrosion. I've found even the slightest amount an cause video fail.

Thanks for all the info folks. I have managed to get a rough monochrome pic by combining the RGB input. I've also positioned the image on the screen with the various adjustment controls but it is a pretty average result when compared to the RGB to HDMI output from same Plus source. RGBtoHDMI...

Finally got this working. Anyone give me a heads up on settings for B&W output from a mac plus. I have a picture but only in RG or B depending on which colour input on the input socket I plug the video out from the Plus into

Thanks for the info. Not sure what to do with it but good to know

Anyone know what a -43 error is. Getting when I try print or setup page on two different computer one System 7.6.1 and one system 9.2. Followed the instruction to install Laserwriter 8 and setup a desktop printer all went well until I try to use it!

Well done you'll be an expert when you do your next floppy repair!