Recent content by MacintoshMan1999

Both, I'll take a picture...

Yes, when I boot off of my SCSI HD the correct date shows.

I've found that when I use an emulated HDD file from MinivMac (The date get's set my the modern computers date and time) it transfers over to the real hardware AND gets saved in mem.

No luck still, In the interim I've been attempting to install Sys 7.5 on my SE with little luck. Any tips?

With the Accelerator attached?

Reseat as in remove and replace the chips themselves? If so I’ve done that too all the chips except the Xilinx, don’t have a tool for that one. Unless you mean the solder I’ve tried swapping different RAM sticks and even tried it without ram in the accelerator, the garbage on the screen has...

No, it does not need an individual power supply. Pics:

Could it be the processor or an IC? Tantalum Caps rarely fail so I'm discounting that.

Whoops, bit of a dufus moment there. I finally replaced all the caps but the bars still persist, at least the fan spins a bit faster. Tried swapping around different ram sticks, tried it without ram, and double checked the jumper settings. I tried the troubleshooting tip in the manual (pages...

Thanks, unfortunately I've already jerry-rigged another cap onto the board...

After a LONG time of procrastination, I've finally gotten around to ordering capacitors for my SE's power supply. While flipping around in a scan of the manual it says that ram at 100ns or faster is required for the 25MHz and I've only got 70ns. Should I get 100ns RAM?

What capacitor have you found to more or less substitute the 620uF 400v cap?

These old capacitor sizes are wack, man. Cap "A" in particular.

I've found a Mac Classic for $50.00, But it's got the 00000000F 00000000D sad mac code. Pick Up?