Recent content by eweri

Okay - where can I get one Sonnet G3 Cache Module? Or a 512kB Cache Module?

The TAM works again - just got a few minutes and I removed the Cache module and it started immediately from the internal disk that I thought was defective. Maybe all the problems this machine had in the last years was just a broken Cache module? I´ll see - for testing I do not put it back into...

Hi Byrd! It last for two or three days. Than I opened the TAM and used compressed air do remove any dust, I clean the contacts of the Cache module and the RAM module with alcohol. When I put back everything and tried to restart, the TAM makes the startup sound and thats all :( the display...

Okay.... Well last week I started my TAM and got a strange noise from the disk and it does not boot. So I thought the disk is gone, Byrd was right. I throw the old disk away and put another 10GB disk into the TAM. I setup two partitions, the first one was about 1GB and it is for the system...

Hello! I had the problem that my Classic with MacTCP 2.1 and System 7.1 crashed as soon as I tried to use MacTCPWatcher and ping it self or another computer. But ping from another computer worked as soon as I started a Browser or other programs that uses TCP/IP. If you use MacTCPWatcher don't...

Hm, i don't think so. It needs at least 7.5.1 and my Classic runs 7.1 Bye, eweri

Hello! Well I found out, that MacIP was always running, but when I tried to use ping in MacTCPWatcher it generates a crash. I played around with MacTCPWatcher from my "MacIP-Gateway" - a SE/30 - and tried to ping the Classic and was surprised that I got ping answers from the Classic as soone...

Hm that is strange. Everywhere I read that I have to select LocalTalk in the MacTCP control panel and then have to select the right AppleTalk-Zone in the pulldown menu - BUT - I do not have any pull down menu beneath the LocalTalk Icon :( Just for curiosity I use IPNetRouter running on a...

Hello! I am looking for an installable ssh packet for A/UX that is running on my IIfx. I found ssh packages on different ftp-servers, but the packages are all damaged :( Some ftp-servers have the ssh package listet in its table of content but in fact the package is not there. I playing...

Hm, okay but how? As I wrote my Classic crashes immediately when I try to use TCP/IP programs. Bye, eweri

:) think if've got it I just reflow the connector pins without success, but than I reflow two smd-resistors between the simm-slot and the mounted memory and voila - the Classics boots up. I can now shake the memory board but the Classic does not crash. At the moment it is running for about...

Well, If i put some pressure at the top edge of the memory board toward the analog board - it works (do not know for how long). I took some paper and pressed it between the board and the metal frame - this way I put some pressure at the lower third of the board towards the analog board - this...

Hm, I looked at the simm slots but I can not see any problem - I cleaned the ximm slots connectors and the SIMM modules. I try to re-flow the first simm socket - I am going to report later. Bye, eweri

So I am not alone ;) Well, I think it is a problem of the connector. I tried to clean the pins, I took my multimeter and tried to find bad connections between the main board and the memory board but nothing. I knocked on every solder point, as long as I put some pressure at the top edge...

Hello uniserver! As I wrote it - I've already done the recap and cleaning of the board. Before the recap the Classic crashed immediately - after the recap it runs with 2MB RAM stable. It only crashes with 4MB RAM after some time. Bye, eweri