Recent content by BobDaAggie

I wanted to give an update. I purchased the BlueSCSI from Joe's Computer Museum and after contacting Joe, I sent it back and he fixed it. Now I have a working BlueSCSI and a fully working Mac SE. Joe said that one of the connections between the Pico and the board wasn't fully soldered. I want...

Okay, thanks for the may suggestions. I have attempted all of them. In my latest log I have found this line: [14312ms] DBG ---- STATUS: 2 CHECK_CONDITION, sense code 0x05, asc 0x00002000 [14318ms] DBG ---- MESSAGE_IN [14319ms] DBG ------ IN: 0x00 in my searching I have found this github...

I saw that but because the external BlueSCSI works with the SC card I dismissed it. I will try that and see what happends

So I increased the time to 10000 and then to 999999 but it did not work. I then deleted the ini file and it still did not work. This is my latest log file Platform: BlueSCSI (Pico2/W) FW Version: 2026.03.01-rel Mar 1 2026 15:12:15 Flash chip size: 4096 kB SPDIF Mode Enabled - I2C Disabled...

Okay, I thought that I had done that with the dwell time but I will check in my system file

So I have finally purchased and installed an internal BlueSCSI for my Mac SE. The BlueSCSI does not boot the Mac. I can boot it off of my external BlueSCSI and when I do the drives that are set up in the internal BlueSCSI do show up. I swapped the SD cards around but nothing I did could get...

One of two ways, I have an oscilloscope that I can see if there are video signals coming out of the BNC or I can borrow an RGB-DVI 300A from a friend. Hopefully I can see the signal.

Finally got around to getting os 6 on my BlueSCSI and success! The accelerator works, now I need to figure out if the Page 2 adapter is working

So the accelerator by itself worked. I will try installing OS 6 on the BlueSCSI and reinstall the display adapter

So I have spent Christmas break working on getting my Mac SE up and running. When I got it, the CRT would not come on. I replaced the CRT and the neck board and the Mac SE booted. I have a Radius Accelerator installed and the Mac SE booted up using my external BlueSCSI and running 7.1. I also...

What fluid solution do you use in your ultrasonic cleaner?

I love the fact that there are amazing skills out there and that open source enables crazy ideas like this. Are 68060 processors more plentiful than 68040 @ 40mhz?

Where did you get your ROM programmer? Also is there a file I can use to tone out my board to make sure my solder joints are correct?

I did try toning out the pins and lines. I do not have a diagram to verify the proper signals but for the most part the tones line up with what I think is correct. What do you think could be the problem?

Hello everyone. I purchased a Mac Plus Rominator. I have soldered the parts together but when I install it I get a checkerboard screen. I think that I might have screwed up the ROM chips. What ROM programmer should I purchase to reflash the ROM chips? Here are some pictures of my work. Let me...