Recent content by aihk

I am using firmware version 1.4.4, ABD to Bluetooth mode, and the computer can search for Quack ADB Mouse, but when connecting it prompts to enter the pin. I enter 0000 or 1234, but it always prompts that the pin is incorrect and cannot connect

How does the Bluetooth mouse connect to the adapter?

@warmech Hello sir, I found out that there is a fault in my RAM board. I insert the memory module in the singular number starting from the right, and the slot will beep wrongly. If you plug it into the double-numbered slot starting from the right, there will be a beep twice, indicating that...

Hello. I'm in the same situation as you. How did you solve this problem?

Can lisa boot without memory and IO board? I mean can I see normal picture with only CPU board?

Lisa keeps making a clicking sound when it turns on, and the rubbish screen keeps jumping. I have an oscilloscope and a multimeter. Where should I start to solve the problem?

Plus's 15.667MHz crystal oscillator is broken, I replaced it with a 16MHz crystal oscillator, but there is a problem with the picture, and the whole picture is tilted. Is there any way to solve it, please

I used your file to make plus, and there was a problem with the checkerboard.

Today, I got a Plus power board by accident, but after the power was powered, it made a daedo sound, and it could not start normally. Experienced friends can I give me to teach how to repair it?

I found that the starting screen of the production can only be full screen, and the 7 system can not be a full screen. The system below 7 must be full screen

What is the format of StartupScreen? I don't seem to see this file in the system folder, is it made by myself alone?

I use the startup disk and want to format the ZIP disk. The driver cannot run correctly. Maybe the reason for the 250 model

I watched the video some people modified the starting screen of the Maikin Tower ~ Does anyone know how to do it? thank you very much

Thank you very much ~ I am going to try the 5x ZIP driver on my SE

This is my situation ~ I installed a 7.1 system on a Macintosh ~ and then put the zip driver into the extension. When starting, the lower right corner shows that the zip drive is an X~ After entering the system, it prompts that the ZIP drive cannot be found.