Thanks.
After recap and replacing DP3 & DP4, I can't bring voltage up enough with PP1.
Only load on the system is the CRT, fan & logic board.
TDA4605 & CNY17 on the way.
Fingers crossed!
Can this board be tested with the flyback transformer disconnected from the CRT? And if so, any special precautions with the HV lead from the flyback (other than not touching it of course...)
I ask because I'm about to recap it (way under spec on 5v & 12v rails) and would like to confirm that...
I'm too cheap/lazy to get a floppy emu at the moment...
I was able to get 7.5.5 installed by pulling the drive from the LCII, installing it in the Starmax SCSI port and copying all necessary files over.
Thanks to your help I've got open transport working and can ping machines on my network...
Thanks for the replies.
I'm comfortable in OSX and the unix command line, but kind of clueless when it comes to older mac OS.
Can I upgrade directly to 7.5.5 from 7.1 without bouncing through any other version?
uniserver, your macccaps.com site was a HUGE help in re-capping the LC II. Many...
Hello,
I have an LCII that I recently re-capped and acquired a DaynaPORT LC II ethernet card for.
I installed the card and it successfully passes the diagnostics on the driver disk. I found the driver in this forum...