• Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.

Search results

  1. M

    Troubleshooting GLUE, C32M, and C16M

    Hi, it pulls down the 1Hz Output from the RTC. After exchange with the originals from the doner board everything is OK.
  2. M

    Troubleshooting GLUE, C32M, and C16M

    Hi, while i am building my reloaded board i find out that it is very sensitive to what kind of surface it is on when testing. Good isolated surface is recommended. Also find out the 65c22 from WDT (Mouser) did not work.
  3. M

    Lisa 1.8a PSU clone by Warmech

    Hi, i must correct my answer. I changed the connector in the Pico-ATX because it don´t fit in the one i used on the Lisa-PCB. Please take a look at the pictures. Regards, Michael
  4. M

    Lisa 1.8a PSU clone by Warmech

    Hi, yes i build this clone too. I put in a ATX-Connector (male) in the big PCB. Then you have to desolder the two ATX Connectors out of the Pico ATX and put in the big one from the opposite side. The 4-Pin connector is useless. I will send you some pictures tomorrow. Regards,Michael
Top