Search results

I prefer more than anything the M1212 apple monitor you can find on eBay from time to time. It's 640*480 and the entire design of it is centered around the pizza box style case. Really makes the setup. As for PSU I recapped mine and it wasn't very hard at all and it's been going strong...

I've been using 32gb TeamGroup cards formatted either exfat or fat32. If you are reusing a card from something else just be aware you may have issues. On my SE I spent an entire day on here troubleshooting only to find out using the SD card formatting utility from the BlueSCSI wiki was all that...

Definitely a great group of people here! I even hit up the IRC from time to time now. Just hate I don't have more time to interact haha

Problem solved! The discord said to format the card with the SD formatter utility from their WIKI to make sure it'c completely fresh and that seems to have worked!

I don't think there is a setting for termination is there? I removed the internal HDD completely. I even used Disc Jockey from BlueSCSI just now to make a blank 40mb image that i specifically marked compatibility for SE and booted off my floppy drive and it still does not show on the desktop...

Ill give it a try. I hate discord with a passion haha. I even tried to create a system disk with the infinitemac online emulator but no go.

It scares me, but honestly after having to messa all around with the running CRT yesterday to get it properly adjusted I am less scared of the analog board I guess haha. Still will not boot any image I try. Just the flashing ?Any ideas guys? Anything inparticular about my SD card or anything...

Yeah it makes me nervous as is haha. I usually discharge for a couple days before messing that deep. I did however reflow the two connectors on the AB and she fired right up. There were some weak looking joints. Now back to the original troubleshooting

I removed and reinstalled the board. I also reflowed the PSU connector on the board. I'm going to try and reflow where it goes into the analog board points as well and if nothing changes I'll have to open the PSU I guess.

It seems to still be very well seated. I'll focus on getting power first and see if it causes an issue. I think I might be up to the challenge of replacing it if so. I've learned a lot recapping all these PITA Macs it seems haha

Yeah my slots do have a single broken tab

Oh I didn't realize that! I'm in the US actually

I don't know if that would be the reason I get no power at all though right? I mean nothing happens at all haha. No fan no nothing. I turned it on and tested the connector that supplies power to the internal HDD which is disconnected and not being used and got no voltage at all. I'm assuming a...

Awesome thank you. Hopefully it's easy to find this stuff gets more and more rare every day

Well I took out all the RAM and used some dexoit to clean the contacts up and make sure they are properly seated. NOW, I turn on the power and nothing at all happens. Highly unlikely it's the PSU I would think since it's a Sony that I freshly recapped. I'll have to find the pin out and test the...

You can if you'd like. I dont know where I can find images that are premade that I know for a fact have the proper disk driver on them. Is there a resource?

Great thank you. I'll have to source 4MB

As in just a basic image with no other images or anything on the SD card. Just the line premade image.

Also, I tried booting just a plain HDA image on the SD card with nothing else of a 7.0.1 install I think it was. Got the error again of 0000000f 00000002

There are pics of the Simms. Probably more than y'all need but yeah lol. I'm assuming by the difference in size that the 2.5mb is probably right. But I'll let y'all be the judge.