Search results

This is clever and fits nicely inside the case. I don't see any cap plague there. There are a couple surface mounted electrolytics that might have leaked, but the through hole electrolytics don't appear to have the plague, else they'd be venting out the top.

Thank you. I will keep this in mind. Just in the short time since I posted this, I found that I have more IIsis that I knew about and at least one of them is missing the top case, so unless more than one has an absolutely destroyed PSU, I should have enough PSUs for each machine with a complete...

What am I missing? I've tried both JLCPCB and PCBway and both of them require dimensions for the board, which I can't find. I've ordered from PCBway before and I am almost certain it pulled the dimensions from the zip file. I'm sure this is a dumb question, but I can't get past the first screen...

@MrFahrenheit Did you ever end up trying this? I spent about 2 hours desoldering almost every component for a totally trashed IIsi PSU yesterday. A few lands are gone and I suspect I will never make this one work again. I've got one more I'm almost afraid to even open. So I'm looking for any...

...unless that's a reference to the Legacy Restore CD which is sometimes labeled as if it were the first of 3 discs in that set. But there were, in fact, 3 discs, and disc 1 had the consumer drive images on it, while disc 2 (readily available) had the edu versions.

Can you share the link you found for Volume 1? I have been trying to find that one for years!