Today, I got a Plus power board by accident, but after the power was powered, it made a daedo sound, and it could not start normally. Experienced friends can I give me to teach how to repair it?
I found that the starting screen of the production can only be full screen, and the 7 system can not be a full screen. The system below 7 must be full screen
This is my situation ~ I installed a 7.1 system on a Macintosh ~ and then put the zip driver into the extension. When starting, the lower right corner shows that the zip drive is an X~ After entering the system, it prompts that the ZIP drive cannot be found.
There is a small board on the logic board~Remove the small board~It will make a sad Macintosh. Memory errors starting with 04. After plugging in the small board, it can be started normally. The startup sound is abnormal. After startup, there is a vertical line. It seems that the memory chip is...
My Macintosh 512K turns on with two pops ~ not a normal startup chime. After booting up, the floppy drive screen will be displayed, and some vertical lines will appear on the screen. Will change, has anyone encountered the same situation and solved it? This vertical line did not appear...
There should be no problem with the cable, the current situation is a gray screen after booting, no boot bell, and no question mark interface on a floppy disk.