SCSI is derived from SASI, it was the precursor, they are very similar, but slight differences. It would be great if you could support SASI for people that need a SASI device (like most of earlier the X68000 systems). I'm not sure why your hardware does not work, there is a patched SxSI driver...
OK, the Mac Hardware/GIMONS 1.47software is working via the SCSI card that I have for X68000 (after I enabled the Terminator, that I did not know about - sorry!!) It does not work via the SASI port that most X68000 have by default. GIMONS version works on both. There must be something in the...
OK, got a little further, I thought some termination issue with the so low level, so I added a terminator to the end of the bus, it then found the drive and tired to boot from it, but had a Read error. So, I'm getting closer!
OK, so the first try as with the Mac RaSCSI and GIMONS 1.5 code, I downloaded the 1.47 version of code and tried that with the Mac Hardware and now it indicates 'So low SCSI Level.' when it's searching for the drives. Not sure what that means, but the out come is different, so the hardware must...
Yes, fullspec is the version and software I'm trying to use. You were talking about the software from Gimons, correct? I'm using the fullspec version from Gimons software with your version of hardware.
Question on the Mac version of RaSCSI - I have the X68000 version from GIMONS and now I also have the Mac version - what changes have been made. I'm trying to use the Mac version on the X68000 and cannot seem to make it work there. I have it working on my Quadra 650 without an issues, but the...