Search results

So now I am going deeper down this interesting rabbit hole.... Does the cache still work when you have the machine in 68030 mode via the control panel, or will it run dog slow like a IIci without a cache card installed?  I assume I'll have to switch back to 030 mode to run AU/X. Are there any...

Well, the price was pretty good so I went ahead and bought it.  I'm pretty sure it's for the 030 PDS, but I guess if it doesn't work in my IIci I can figure out which Mac II it's actually for and try to resell it at a little bit of a loss. Thanks guys.

I was under the impression that there were different models, for different models of Mac.  Was there only one?

I may have a line on a Turbo601.  The seller isn't sure what model it's for, and I am not turning up much on the web about how to determine whether or not it will work in my IIci. Do any of you have any advice? Thanks, folks.  I really appreciate it.

I've had several ROM1 boards pass through my hands, and none of them have had these mods.  Were it me, I'd probably document the modifications (so as to be able to redo them later if needed), then try to put it back to factory and proceed with repairs from there. If I get time tonight I might...

Yeah, practice a little on a junk board first like they said. But don't overthink it too much.  You just need the right value caps in the right places, with the polarity the right way.  I've recapped Mac boards with through-hole electrolytics (because I didn't have the right SMD components on...

I think those Zilog rs422 chips were used in a lot of other machines.  You ought not have tremendous trouble finding donors, I wouldn't think? I have a ROM3 board that took a Maxcell Bomb to the face that I've been trying to fix, even though it is pretty hopeless (seriously man, it is *bad*...

(Disclaimer: I'm just a hobbyist and I don't really know what I am doing half the time.) If you have the appropriate test equipment, I'd start by checking to be sure that there isn't a short to ground on the power rails.  Certain types of capacitors can form a short circuit when they fail (old...

I'm sending him my spare ROM1 mobo and a RAM card, and he's sending me his dead one to try to fix.  It'll be an interesting project.  It looks pretty dire to me, lol, so I'm not gonna hold my breath.  Gunna have bodge wires stacked so deep underneath that it won't snap back over the tabs.  :3

When I did my IIci, I was out of SMD electrolytics of the correct values, so I just cut the leads on through-hole electrolytics really short and soldered them to the pads.  It actually worked far better than I expected, and I think I'm going to just leave it that way until they start failing (I...