Search results

Just what I need, thanks!

Thanks, I will give them a try

I think this was the seller I tried on eBay and it got cancelled. Probably was not thier fault.

I ordered a Lisa keyboard pad repair kit from an overseas eBay seller, but my order disappeared and there is no trace of the seller anymore. Does anyone know of a seller that can supply the repair pads? I could make them myself but would much rather buy a premade set.

Thanks mg.man 🙏

That worked! Although it worked better if I did one file at a time. Thank you!

I successfully installed the Lisa 3.1 OS from the Floppy Emu Lisa onto my Lisa 2/10, but have been unable to install the Lisa 7/7 Tools (LisaWrite, LisaDraw, etc). Were they supposed to be installed during the LOS install? If so, I have not located them on the hard drive (9k free "blocks", 13.5k...

I did register at lisalist2, but the admin still has not approved the reg. 😤

Fixed! It was a bad sd card in the Floppy Emu. I got a replacement from BMOW and was able to use the first Office System image to get the hard disk initialized (in two parts) and LOS all loaded up and running.

Found from a previous post from you: "To install the Office System, you will need to boot from the first Office System disk and follow the instructions on the screen." After I get the hard drive mounted on the desktop?

And install LOS?

Thanks again for your insights stepelton much appreciated. After much effort I did manage to get BLU onto the Floppy Emu and run it on the Lisa. I did the E - Exercise/Test Disk for several minutes with no errors reported. I then did a L - Low Level Format successfully. Now how do I get the...

I forgot iit did display a "read error" in the upper left hand corner.

After getting my Lisa 2/10 up and running, I was able to boot from the Widget into MacWorks XL. But it has started to hang during the boot process. The HD activity light would flash rapidly then go steady. Hitting the interrupt button would get it going again, including a momentary pfs:file &...

Now tryinng to move the Lisa office files on the Floppy Emu to the hard drive. Should I attempt to switch to Lisa office or leave well enough alone? It has the H/88 ROM.

After reseating the cards and some of the chips on the Widget, and tweaking the pots on the Widget's motherboard, it now boots up to MacWorks 😀 I can also erase/write/read the floppy drive. I think the real trick was cleaning the Lisa's cover panels. This old girl still likes to look good!

Fixed!!! The problem was that I configured the EMU for Mac disks rather then Lisa Disks. Since I could select disks in the Lisa menu, I thought they were Lisa disks. So I reconfigured it for the Lisa disks, but still didn't get it to boot until I selected one of the MacWorks disks. Aspect ratio...

Whats the best way to make a boot LOS floppy?

Both the EMU and the floppy drive show an error 38 code

Same result starting with the EMU using the Lisa Office D1 img