the 6290m is exactly the same as the 6280m but with 2x sata ports instead of ATA connectors; unfortunately can only support 2 drives instead of the 4 supported by the ata version
i just tested my 6880M card in a 450Mhz Sawtooth AGP with an 80gb SEAGATE 7200.9 7200 RPM 8MB Cache SATA 3.0Gb/s drive (in non-raid mode) with ATTO Express tools
Peak Read: 70.63 MB/s
Peak Write: 69.51 MB/s
Sust'd Read: 62.52 MB/s
Sust'd Write: 58.21 MB/s
the result was the exact same with...
if you need a sata card just contact michael using the contact form @ www.firmtek.com and tell him what you need
you will get a tracking number response immediately and he ususally responds to emails within 24hrs
if someone could figure it out i bet you could tape some pins on the card to prevent it from not working in the QS
there are other cards that have an electrical incompatibility in this fashion.. and it must be an electrical incompatbility in the way the card is constructed
conflicting with...
can someone share this version of hte seritek firmware?
am i correct to think that this is only available to people who happen to have an early revision card with the firmware on the cards flash chip?
please share this version
id say the macintoshrepository site has you covered
https://www.macintoshrepository.org/11913-codewarrior-dr1-gold
https://www.macintoshrepository.org/11915-codewarrior-pro-2
https://www.macintoshrepository.org/1116-codewarrior-pro-3...
yes the 64XTC works fine on a windows computer!!!!!!! recently hooked it up to a pII 266Mhz slot 1 440bx board running windows 3.1 works 100% running windows 95 works 100%
back to the 5200CD...
for the record there is no Modem in the commslot
i just pulled out the motherboard to check...
just to make a record, and to answer more clearly + illustratively Cory's earlier questions:
heres a few images to show what the error is when my interface refuses to function properly..... everythign else is properly configured trust me..
swapping it out for the opcode studio 3 yields better...
is it normal for the system software to take 5.5MB of RAM?
this is another reason why i was going to go to a 68k cpu,
vintage software ram requirements are less than half required by software when powered by a PPC cpu.
P/N: 04160D00
Model: Z250USBPCM
date: 11/01/1999
07:23
assembled in USA
5v 1.0A
i have also got the firewire adapter which connects to the db25/SCSI connector:
P/N: 30195800
Model: ZIP1394A
date: 10/05/2000 22:07
here i just found the manual for the zip1394a: ...
it has an icon that looks like a optical CD-ROM
it says : System 7.5 update 2.0
1.1mb
created Aug 21st 1995
can anyone tell me the proper name so i can rename it back to what its supposed to be
wow its really annoying how this site concatenates links
https://www.fenestra.../tn/tn1018.html
http://web.archive.o...ac/macmidi.html
are u the 68kmla.org owner/operator/admin?
that block diagram is in no way conclusive -- just because it says "SCC" on the block diagram does not mean that its the same "SCC" etc etc
the F108 is not a memory controller but rather an ASIC (Application Specific Integrated Circuit) and you arent shedding any new light or information in...