-
Hello, Guest! Welcome back, and be sure to check out this post for more info about the recent service interruption and migration.
Nixontheknight's latest activity
-
NNixontheknight replied to the thread Killed an MDD logic board.I'm ok with the risks as long as it gets my MDD working
-
NNixontheknight replied to the thread Killed an MDD logic board.The logic board is a 1.25GHz board so it's going to be 167, and the 1GHz card is 133MHz bus
-
NNixontheknight replied to the thread Building a new LocalTalk (and LToUDP) to Ethernet gateway.Will you be selling this or will you provide the files to make the PCB?
-
NNixontheknight replied to the thread Killed an MDD logic board.I'm gonna try changing the bus speed on the 1GHz card
-
NNixontheknight replied to the thread Killed an MDD logic board.The PSU is known good, I have not done a PRAM reset but I believe the bus clocks are different from the card to the motherboard, and...
-
NNixontheknight replied to the thread Killed an MDD logic board.I turned it on with a 1GHz CPU card and the light just flashes and fades away, then it's silent, then the fans ramp all the way up
-
NA few months ago, I was trying to overclock my MDD (rev A from 2002) from 1.25GHz to 1.5GHz, so I could get DiscordPPC to run properly...
-
NNixontheknight replied to the thread LC Power Supply interchangeability?.the 040 LCs don't need more oomph. Byte Knight (the sysop of CQII) put an LC 475 logic board inside an LC III, and it has worked with...
-
NNixontheknight replied to the thread LC Power Supply interchangeability?.AFAIK, the power supplies from all pizza box LC machines are interchangeable. I have an LC III that has a power supply that has the same...
-
NNixontheknight replied to the thread Concept: LC Microdrive III: a Rom for LC III users to boot without a hard drive for recovery purposes.yeah, it would be nice to make Microdrives for all the Macs that have extra pads for a ROM or an extra ROM slot
-
NNixontheknight posted the thread Concept: LC Microdrive III: a Rom for LC III users to boot without a hard drive for recovery purposes in Hacks & Development.As i was looking at my LC III today, I found out there’s some unused pads for a ROM of an unknown capacity, then I remembered the...
-
NNixontheknight replied to the thread LC475 memory issue(?).as I said, try seeing if the traces that go to those chips are interrupted somewhere, like they're cut, corroded, etc.
-
NNixontheknight replied to the thread LC475 memory issue(?).The modem port is probably geoport. And as for the memory, I’d tone out the connections for the RAM using a multimeter in continuity...
-
NNixontheknight replied to the thread PowerBook 520c Screen Issues.it's common for ribbon cables in laptops to break, so I would say replace the ribbon cable going from the logic board to the display
-
NI have a 1.25GHz MDD dual CPU card from a rev a MDD from 2002 that I blew up due to over voltage. Does anyone have any spare 7455s or...