When SD cards advertise transfer rates, I think typically that is maximum burst transfer not what the card is rated at for constant reads/writes which is far more important for using it as a hard drive. For a scsi2sd I don't expect you'd need anything higher than guaranteed 10MB/sec sustained...
There's actually a second one next to it but out of view because it's right along the side of the case. 168 pin EDO DIMMs, I think I probably have some extras from my StarMax or 9500 builds.
The PSU looks enclosed in this plastic casing and runs along the side of the unit where the fan is. Strange design but the whole thing is pretty small for a desktop computer.
I tested an LC 550 board in the Color Classic and it turned on but the hard disk's OS is too old to actually boot it, but at least I know the thing works. The IIvi seems to work just fine but I'll still need to recap it and throw some spare NuBus cards in for fun. My research seems to indicate...
I was bored at work and opened up FB marketplace which I rarely bother looking at since most local ads are like $500 Classics because "they go for $1000 on ebay" but noticed a stack of Macs for $40 and the ad was just posted. I was probably the first person to message and I said I'll pick them...
I would strongly recommend learning to read the values of each capacitor and then place your order based on that. While logic boards will all USUALLY be the same, PSUs and analog boards (if you have any of those) may have different vendors/models/revisions and the caps list will vary. This might...
Finished my recapping and nothing blew up. Some of my film caps were much smaller than the old ones being replaced so what I did with those was mostly had 1 leg lined up with the hole and the other leg bent a couple times to fit the second hole. Had to make sure I ordered one with long leads. I...
I'll be recapping mine this week. I accidentally ran out of solder and some of the film caps I ordered aren't the best fit so I'm going to try some others. I can probably remember to update the thread if it works or not.
I didn't order a 2uf film cap for mine but here's an example of the 0.22uf capacitor I'll be using in my PSU: https://www.digikey.ca/product-detail/en/kemet/R75PN32204030J/399-12762-ND/5731253
I believe I used this same type already in my IIgs.
Every LC power supply I've taken apart so far has had cap leakage, even the ones that still worked. On the plus side they're the easiest power supply to work on in my own experience.
Unfortunately I haven't tried mine out yet so I'm not completely sure on the details yet. I was probably going to try ProTools 2.0 which is for 68k and I'm assuming supports the Nubus boards. https://macintoshgarden.org/apps/pro-tools-20
MacOS stops showing model numbers after 7.1 I believe. The very first 7.5 might still do it but I've never seen it on anything beyond 7.5.x.
The Digidesign stuff more than likely is for audio recording to interface with something like Protools. The cards are mostly useless unless you also have...