Recent content by macsonny

Sweet. Do they have a similar solution for the Mac SE or Mac SE/30 do you know?

I just left a gap between the bezel of the compact Mac and the LCD screen. Looking front on you can't see the gap anyway. Each to their own.

Yeah, I found 9.7" was a little large but after modifying the under scan it now looks perfect. Very happy.

Found an app called BetterDisplay. Worked a treat!

Hi All, I've placed a Mac mini into a Mac SE/30 case and then installed a 9.7" iPad screen with driver board to create a cool little Mac unit. I plan on running a Classic Mac emulator on this unit. One issue I have is that the screen size is bigger than the size of the Mac SE/30 front panel...

Happy days!!!!

Just removed the U7 and starting some testing now. Will report back.....

Thanks for tip. What's easiest way to remove the 16 MHz signal?

Oh wow - fantastic link. I'm very comfortable removing the U7 IC but just wanted to check I get the bodge wire correct which looks like it goes from PIN #1 of U5 to PIN #7 of U7. Is that correct?

Looks like it's called a MicroMac Performer. I managed to find the drivers but apparently just works without them. My only concern is that the PDS connector I bought looks like it might cause the card to be too high when installed. Does anyone know if there are "low rise" PSD slots that can be...

Hi All, I have picked up a MicroMac card per attached picture. Note that it apparently came from a Mac Classic but I believe it's supposed to work in a Mac SE as well. I had to purchase a new PDS slot connector and will solder in the next few days. I of course made the assumption that if I...

Bump

More progrès.. Changed out power supply and unit now starts up fine (no fluctuations) but sill horizontal white line. Any new suggestions?

Did a reflow of suggested pins on analog board and also neck board. I have now noticed an odd re-boot sequence - wondering if the power supply is failing? See attached video.

I'll give that a go tomorrow and report back.