In addition to these articles:
sudo nano /etc/sysctl.conf
- Find the line net.ipv4.ip_forward=1 and remove the # symbol at the start of the line.
sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
- Do after every reboot of pi, or make a script that does this so you don't have to...
MrGasS27
i just spent many many hours over many days trying to get somewhere with my Pi3 and my Classic II. I finally had some luck with the following posts.
https://jeffhacksthings.wordpress.com/2017/05/14/raspberry-pi-ppp-serial-router/...
Hey jamesmilne, I got further with your setup than I have with all the others I've tried.
Would it be possible to show me how you set up your iptables forwarding (and might as well show the work on the IPv4 packet forwarding, although I think I've go that already).
Thanks for your time and...
So I just read the sticky post about software requests and I guess this post is out of bounds.
I'll leave it up until someone tells me to take it down, but (and here comes the excuse), I'm pretty sure that this software is no longer commercially available and is so incredibly rare that it...
Hello folks,
I've acquired a MicronEye Bullet camera for Apple II or Mac and I can find the software for the Apple II but I'm looking for the Mac software.
Theres a post on eBay with a photo of the floppy (400k) so I know it's out there.
But I've used up all my Google knowledge and...