Recent content by likanen

Ok, I think for PB100 one needs to use SSD adapter as the native adapter (or two side clips) are side mounted.

Does someone have a 3D model for scsi2sd PowerBook edition adapter to 2.5” frame?

If I only had one :)  Anyways I found the problem (I had accidental dropped solder on a memory chip, it is visible on the logic board picture above) and the computer now boots to a flashing disk screen. The HD is marked as bad, and it didn't do much than whining when attempted to start it up...

Hmm, did some trials and it seems that the computer starts up (almost) every time if I plug in the battery first. It doesn’t boot up with charger only (I guess this is expected) and I need to RESET + NMI it to get it to boot if I plug in the battery after the charger. So... most probably it...

Hi, I would appreciate some guidance... I recapped "recently" (like year ago or so) acquired M5120 and plugged it in for the first time. I got a chime and a sad mac. While trying to make it easy to access the board while powering it, it did a smoke on pin 10 on J22 (yes, it is a ground pin but...

Please find attached some more pictures. The power supply is with AT connector and has been attached to the Lisa monitor power in. Then Lisa’s video / logic board connector is sliced and a regular Mac compact connector has been connected to it. I know nothing about Lisa connectors so my...

He used Lisa shell for it. 

I will. There are 4 other compact macs and various analog and logic boards so I’ll try to sort them out first. That stacked memory logic board just stroke as was it couldn’t fit a compact case so asked the guy how he had been running it. 

The board is 512K but here is the photo. 

Sorry to revive this 5 years later but I obtained a similar 128K board with a stack of ram. The lot also included empty Lisa case with non-standard PSU in which the board had been. The seller had modified the board and Lisa by himself (afaik) and he used to work at it department of a local...

Finally, I can report a success (I hate when people don't finish a topic they started, if it got resolved or not). Sound and ? floppy. The sound problems I was able to find a potential cause from here:  And it was indeed a broken data line to ASC (among many others :) ). Funny that the...

Thank you @Bolle, I found UC8 pin 13 not connected. After fixing the A(11) connection the picture looks good (I guess I could have taken A(11) closer to UC8  :lol: ). The programmers button still produces same error code (0000000F,00000013), I've lost whatever sound I had (some beeping), and no...

Thanks! Is there a chart where each should be connected or how should I test the lines? I tried searching the forums earlier but I couldn't find a chart.

Spent couple of hours cleaning the board even more, adding jump wire for C6, found that trace between circled leg and and its other end is broken, jumped it. Anyways, no change in out come except some attempts to play something from audio but it also fainted away after few resets. I also...