Hi I have a common Asante MacCon Ethernet card that came in an SE/30 originally stacked on top of a Diimo. The Diimo is missing two caps but when I plug the card into the PDS slot (the logic board was just recapped by me) - the entire machine just clips, clicks and won't power on anything...
Well this one is where the 030 board gets plugged in - the board into this fan unit - then this gets plugged in presumably from the vacant connector w the one pin a bit wider than the rest. Do you see the connector now here (not the one w a cord plugged in)? It's the same kind as the psu we've...
Thanks for the tip! Btw - what's the cable called that runs off the Meanwell? It's the same 4-pin connector on my fan pictured above w one of the pins set off to one side...
Full disclosure - i tinkered w running power from CRx and started a moderate electrical fire inside my Plus. I have a different problem now :) I'm in timeout until I can find a manual.
Hi I have a couple of 030 Mac Plus accelerators and both hAve a way to grab extra power via red and black clips that I recall clip on to a resistor on the power sweep board. Does anyone know which resistor you can do this with? I just can't find a manual around this task.