Due to the limitation of SE board (68000), you cannot use 20mb of RAM, only RAM installed on the Mobius 68030 board can be used (16mb max).
To optimize SIMMs installed, the Mobius driver allow you to use SIMMs installed on the SE board (4mb max) as a RAM disk, it's better than nothing ;-)...
Hello,
I have the same, but 25Mhz version, not 33Mhz.
But the position of the jumper is the same :
RAM :
Jumper to 0M = No RAM on the Mobius board.
Jumper to 4/8/16M = four SIMMs on the Mobius board (four 1MB or 2MB or 4MB SIMM).
By the way, if you have 70ns SIMMs, you can remove W12...
I can do that, but the MiniScribe is not very fast ;-) , more than HD20 due to SCSI, but very low compare to next SCSI HD.
To show you, I run Speedometer 3.23 on a SE/30, with the external 20SC, and the internal Quantum LPS525S (500Mo).
HD 20SC Miniscribe :
Internal LPS525S :
520c run with 7.5, which is HFS only, and, as all 68k, even if you run 8.1 to use HFS+, it cannot boot on HFS+ volume, only PPC can.
540c run well, but no battery inside (all dead), and PRAM battery is empty. And I need to wait a couple of minute after to plug power supply to be able to start...
I already tried the PCMCIA module (revB) to use CF card to boot on my PB520c, that run well :-)
The CF card appears in the Finder (I was able to format the card). I put a copy of the system folder from the hard drive and was able to boot from the CF card:
I also tried to do that in my...
No worries with internet for my use, connected only for the automatic update of the TV guide.
I use a small USB DVB-T tuner connected to an antenna (for digital terrestrial HDTV).
With the little Apple remote, I do not even have to leave EyeTV. I do not even use the OSX interface, I put it to...
Argh ... it's not very far from mine ...
I use it every day, several hours a day, as a TV in my kitchen ;-)
With a USB Stick EyeTV for TNT-HDTV, it serves me to watch TV (and record).
It works very well, in automatic start on EyeTV. In fact I only use the small white Apple remote to put it...
This display, SHARP LM64P51 has been used for the PowerBook 140 and some 145. You can replace it by the same or by the second model for 145/145B (SHARP LM64P58), but it is paired with the inverter board (find the pair, display + inverter). The CCFL backlight lamp is easy to replace.
There is a...
This card was also an option for the MacMemory TurboSE.
In searching information for the TurboSE, I found a test in BYTE (March 1988) which explain that.
https://archive.org/details/byte-magazine-1988-03/page/n157
I found a test of this card in BYTE from March 1988.
https://archive.org/details/byte-magazine-1988-03/page/n157
This confirms that I need an INIT software to use the 68881. But no way to find it
If anyone has it ...
It also explains the use of the connector on the card, which was an option...