I have a mac plus to test, the PSU it's givig out nothing and I want to test the motherboard, I have a RGB2HDMI that's working with my Classic II , I tried to give 5v to the motherboard, but I had no sound or video, I could see the current ramp up, and if I pressed the resed it would go down...
I spent the last 2 days recapping and cleaning this Classic II, 220v, and I'm extremely unappy to discover that I have nothing out of Pin 2 of the flyback transformer, there is no 12.6v output to the pin 2 of the TEA2037, everything boot and I have a bright horizontal line on the screen,event...
Ok, I don't understand what happened but my SE is fine, took it apart, put it back together and it was good to go, clealy it wasn't happy about the video signal.
So, I tried this and tested the cable before plugin it in, it has worked for a short while, but the image was reveresed and I had white horizontal lines on the screen, sadly, that was it, I shut it down quickly but now I don't have any picture on my SE with the SE board plugged in, I have 12v...
Good evening!
I recently acquired a Plus an SE FDHD and a Classic II, I recently recapped the Classic II but I wanted to test it before I start to recap it's analog board.
I have a fully working SE, I notice the connector for the analog board it's the same, can I just connect it?