Search the Community
Showing results for tags 'pcmcia'.
Hopefully, this would come in handy for anyone curious about the PCMCIA module made for the PowerBook 500 series. I've posted as many pictures from various angles of the board assembly and parts (in case anyone has interest in planning modifications and how much space is inside the module) as I don't intend to open this up very often. If at all. There are three hex screws, one plastic tab, and a sticker holding my Rev C module together. I didn't have a hex bit of the correct size, but a Torx T6 proved a snug fit that allowed me to remove the screws. When I depressed the plastic ta
Greetings all, Very kindly a friend of mine has dug a working Newton out of his attic and is going to hand it over this weekend (what an awesome dude!). In preparation of this momentous event I've been powering up my old hardware so that I can 'sync' with the Newton, and therefore install new software etc. I installed the connection kit for classic OS onto a G3 iMac I have in the workshop. I don't (yet) have a physical cable but maybe one will be included in the bag of goodies (fingers crossed) so I was pottering around and dug out a box of ran
Hi Folks, First post here on the forum after lurking for years, hopefully its not presumptuous leading with a request but I'm in a bit of a jam: I've purchased this Seritek 1SM2 card, looking to use it with OS9, support is described as 'limited' but present nonetheless. No luck using the re-packaged drivers from the Seritek website or on the CD it comes with. I have been in correspondence with Firmtek trying different solutions and all existing Extensions seem corrupted by OS X repackaging. I've gone through quite a few variations of dragging and dropping the 'SATAEnabler' file into