Jump to content
Johnnya101

John's Classic Restoration Thread

Recommended Posts

Well folks, its certainly chugging along... Slowly.... but its coming out nice. Its actually just turning lighter just by drying out in the open! :0

 

ybR17tI.jpg

 

Now its a lighter baby puke beige. Some minor streaking everywhere, but it should go away. The handle streaking went away, only to be replaced with some more light streaking :/ Probably two, maybe three more sessions and it will be platinum again. Then on to the keyboard and mouse! (PS. Was the mouse in 1991 with the Classic a rectangle one or teardrop?)

 

 

Edited by Johnnya101

Share this post


Link to post
Share on other sites

Getting closer... Dont know whats going on in the photo with the weird haze on the front panel, thats not there. Color is now a slightly lighter and more even beige. Looks like any old compact that has been sitting in a closet now. Still blotchy white and yellow, not from me, it was like that to start with.

 

Again, sorry for the weird colors and lighting. Had to use flash.

 

KC4I4CD.jpg

Edit, here's a photo of the comparison between the back of the adjustment door and the part of the case covered by the front. A lot closer than I thought. Probably 2 more light sessions or one all day one.

yhpFVEq.jpg

Edited by Johnnya101

Share this post


Link to post
Share on other sites

Finally... A decently lit photo.

 

Had the case with cream on it for around 7-8 hours today but still only under a UV lamp. Dark and cold out :(. If I had just a few hours of wamrth and strong sun it would be done. Still a light beige tinge to the case, no streaking at all (yet). The front bottom is still yellow, along with the front top edge. NOW I can accurately say with confidence 2 more sessions top and it should be good to go. It's super close... Now it's the same shade as my SE/30. Can't believe that blue tape has held up through the hyrdrogen peroxide and shower baths.

 

Whaddya think TechEdison?

 

pqVBfRF.jpg

 

Share this post


Link to post
Share on other sites

Cleaned and lubed the floppy drive, cleaned up the backet, CRT, etc. Sent the analog and logic board out to get recapped. Put the rest back together to clean up the pile of parts laying around.

 

I think this one was a sucess.

nCHxE4B.jpg

Very very very minor streaking on the top (why is it always the top?). Seems to have gotten a lot better after drying overnight. One of the sides is a little more yellow then the front panel side edge. I'm leaving it as is, no way am I going to risk this.

 

It was super bright and sunny out yesterday in NH so I decided to do the keyboard and mouse too. Keyboard is pretty much fully there (had to remove each and every one of those stupid keys) and.mouse is spot on.

 

I'm happy with the results. Now we wait for the recap.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×