• We've made some quality of life improvements to the Trading Post. More info here.

Voltage drop after installing a Diimo 030 PDS

Belka2

6502
In my SE/30—which has had its power supply capacitors replaced, thicker wiring installed, and four expansion cards added—the voltage at the floppy drive connector is approximately 4.75–4.78 V. The computer runs perfectly, even when launching demanding games (such as Warcraft).

However, once the Diimo 030 card is inserted (into the PDS slot), the voltage drops to 4.72–4.74 V—even when no other cards are installed. The computer fails to boot: there is no startup chime, and black bars appear on the screen.

Is this kind of voltage drop normal when installing this card?
Should I increase the power supply's output voltage, or should I look for a fault within the Diimo card itself?
 
Hi Belka the measured voltage @ 4.75V and below is marginal and with added expansion cards the PSU is being overloaded. Some SE/30 PSUs allow you to adjust the voltage, but not all models. I would look into this to attain a healthy +5V and retest, there are also aftermarket PSU options to consider, which I would recommend long term if running 4+ PDS cards inside the system.
 
Last edited:
Hi Byrd!
I have a Sony; currently, with no load, the output voltage is 5.35 V. I could increase it to 5.5 V.

However, I suspect that the issue is not caused by the voltage being too low.

I removed the board from its case and connected it to an ATX power supply using an adapter. With four cards installed (Interware Booster, Asante, a graphics card, and a NuCF card by Zigzagjoe), the voltage at the floppy drive connector is approximately 4.8 V.

After removing those four cards and installing only the Diimo card, the voltage drops to 4.72–4.74 V. (Neither a hard drive nor a floppy drive is connected to the system.)

Is it possible for the Diimo card to draw that much power — more than the other four cards combined?

I suspect that the Diimo card might have a short circuit. Has anyone encountered a problem like this before? How can I verify this?
 
Hi,

Can you please clarify did the Diimo card ever work in your hands? Physical inspection of the card would be next, if not familiar with using a scope (I'm not), you could try this amazing new application to troubleshoot your SE/30:

 
The Diimo is a power hungry card. CPU, FPU, 12 GALs, and 3 TAG SRAMs all burn quite a bit of power. I don't have any reliable notes handy on Diimo's power draw but I wouldn't be surprised by one drawing more power than NuCF+30Video+Booster combined. Can't recall the MacCon's draw, but it shouldn't be too bad.

Diimo does have a few tantulum caps which could potentially fail short, but you'd likely have noticed (in spectacular fashion) if any had actually failed.

When adjusting a SE/30 PSU, it needs to have a nominal load on both the 5v and 12v rails as otherwise the open circuit voltages will climb unrealistically. Simplest way to do it is with a stock machine, floppy, CRT, logic board, and a HDD; you really want to see 5v at the logic board (as measured by floppy or PDS) with a "stock" machine. Given you know that you will be putting at least one power hungry card in it, it's okay to aim higher, but take care that your +12v rail doesn't exceed 13v.
 
Back
Top