Performa 6200 — ADB power-on works but no keyboard/mouse input

[mndeaves]

Might be how I was counting the pins or setting up my meter. Fresh eyes this morning show me it is the pin highlighted with continuity to pin 1. Multimeter set to the the speaker icon/200 Ohm settings with speaker enable. Just to check I'm not losing the plot, picture of the jumper wire I have in port 1.

 

[Phipli]

Might be how I was counting the pins or setting up my meter. Fresh eyes this morning show me it is the pin highlighted with continuity to pin 1. Multimeter set to the the speaker icon/200 Ohm settings with speaker enable. Just to check I'm not losing the plot, picture of the jumper wire I have in port 1.
View attachment 95866View attachment 95867
View attachment 95865

That's pin 20 that makes more sense

 

[mndeaves]

Realise now the Cuda chip is actually programmable by the sound of it, so just swapping it in with one that hasn't got the same firmware on it is not going to work. I guess at least we have connectivity to pin 20 and as you say, the soft power works so the chip firmware should be ok. I re-flowed R85 and it now sits flatter on the board but still.. same symptoms.

 

[Phipli]

Realise now the Cuda chip is actually programmable by the sound of it, so just swapping it in with one that hasn't got the same firmware on it is not going to work. I guess at least we have connectivity to pin 20 and as you say, the soft power works so the chip firmware should be ok. I re-flowed R85 and it now sits flatter on the board but still.. same symptoms.

You want to trace out from pin 19 next - check if it goes to the resistor, then the transistor, and then the other resistor. Perhaps reflow each (don't put too much heat in the transistor, some are super heat sensitive, perhaps leave it until last)