Recent content by vetz

Thank you for your suggestions, I'll check it out. The reason I want it to boot from the harddrive in this case is that I want to copy some files from an image to the internal harddrive. If I add the BlueSCSI tools image it tries to boot from it even if its not a bootable image. I'm also...

I have an issue that whenever I have my external BlueSCSI connected to my Mac IIci it always boots from the BlueSCSI no matter the ID on the images on the SD card. I've doublechecked that my internal drive has ID 0 (540mb upgraded harddrive done in 1994 by previous owner). This only occurs if I...

There is a -22v for the backlight (measured to -21v) I checked the databits from the J12 connector and I couldn't see anything special difference between upper and lower. I do not have a oscilloscope available right now so I had to use the Hz setting on my multimeter for checking. No, its...

I checked the voltages and they were the same to both set of drivers at just above 5 volts. Anyone have some more ideas on what to check?

Forgot to mention, but I already checked continuity as it was a tip in that other thread and that was fine. I used 35v 3.3uf tantalums caps. I've used the same ones in a PowerBook 150 with no issues. Mouser link: https://no.mouser.com/ProductDetail/581-TAJB335K035SNJ Will check voltage on the...

I bought a PowerBook 100 and it didn't even power on the first time I tested it. I've done the following: - Recapped caps in LCD panel, replaced with tantalums - Recapped all SMD capacitors, replaced with tantalums and polymers - Opened up the Conner drive and unstuck the head. Generally there...