• Hello Guest! We're hosting a challenge to welcome vintage Intel macs to the MLA during the month of July! See this thread for more information.
  • We've made some quality of life improvements to the Trading Post. More info here.

Recent content by gsprod

  1. gsprod

    KEYSTRON MK2DS168E-60 16MB 30pin EDO for a Macintosh SE/30

    thanks for your advice.
  2. gsprod

    KEYSTRON MK2DS168E-60 16MB 30pin EDO for a Macintosh SE/30

    Thank you @mikes-macs Are your memory recognised with a stock original rom ? Are thet considered as 4m stucks or yoy are getting errors ? Thanks again. G.
  3. gsprod

    KEYSTRON MK2DS168E-60 16MB 30pin EDO for a Macintosh SE/30

    Hello there, I bought 8x16 MB EDO 30-pin memory sticks on Amazon, hoping to use them in my newly recapped Mac SE/30. However, when I install them (4 of them), I get a garbled screen. If I replace the first stick with a 1 MB stick, it works, but I only see 4 MB. 1. I know all the sticks...
  4. gsprod

    SE/30 recap - capacitor pads lifting, looking for advice

    Thanks to all of you guys!!! So I finally used the method of cutting the capacitors with a Hakko cutter and then removing the IC legs with a soldering iron — not the twist method, the cutting method. It worked like a charm. I recapped my SE/30, and everything is working fine. I’m letting it...
  5. gsprod

    SE/30 recap - capacitor pads lifting, looking for advice

    Im going to try to that.. before un ruin the full mother board
  6. gsprod

    SE/30 recap - capacitor pads lifting, looking for advice

    Hi everyone, I'm working on recapping my Macintosh SE/30 and I've run into an issue: when I remove the old electrolytic capacitors (3 so far), the solder pad lifts off the board with the cap. I'm wondering if this is due to: - the type/quality of flux I'm using - my hot air temperature -not...
See more
Back
Top