• Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.

SE accelerator - what's going on with this board?

JC8080

Well-known member
I'm looking at this old 16mhz 68000 accelerator for an SE, and I can't quite figure out what's going on with the PDS connector. I know this style of male PDS connector with just exposed pins and no plastic surround was seen on other boards as well. What I can't figure out is why it appears the pins aren't soldered to the board. In the photo of the full back of the board, you can see many of the pins are bent, it looks like someone removed the card at an angle by pulling up on the far edge. I asked the seller about the bent pins, and they attempted to straighten them, which is why they look different in the close-up photos. I asked if the connector was loose, thinking maybe someone had removed the PDS connector at some point and just set it back in, and they said nothing is loose. I also can't tell if the pins are rusty, or if they just appear that way in the photo. No other part of the board looks corroded to me.

Does anyone have any thoughts about the seemingly un-soldered pins, or the condition of the connector?
 

Attachments

  • Card back.jpg
    Card back.jpg
    356.7 KB · Views: 50
  • Card front.jpg
    Card front.jpg
    348.1 KB · Views: 53
  • Close connector 1.jpg
    Close connector 1.jpg
    428.9 KB · Views: 54
  • Close connector 2.jpg
    Close connector 2.jpg
    471.6 KB · Views: 44
  • Close connector 3.jpg
    Close connector 3.jpg
    408.1 KB · Views: 42
  • Close pins 1.jpg
    Close pins 1.jpg
    296.8 KB · Views: 42
  • Close pins 2.jpg
    Close pins 2.jpg
    278.9 KB · Views: 44

mdeverhart

Well-known member
I’m not sure, but I think it’s likely that’s a press-fit connector. Press-fit connectors use plated PCB holes that are close in diameter to the pins, and the pins have spring “wings” on their sides. During assembly the connectors a literally pressed into the PCB holes, and you can get a strong mechanical and electrical connection without soldering.
 

Phipli

Well-known member
Interesting card - it is a video card as well as an accelerator. It uses an ST branded 68000 too.
 

JC8080

Well-known member
I’m not sure, but I think it’s likely that’s a press-fit connector. Press-fit connectors use plated PCB holes that are close in diameter to the pins, and the pins have spring “wings” on their sides. During assembly the connectors a literally pressed into the PCB holes, and you can get a strong mechanical and electrical connection without soldering.
Cool thanks for the info, I hadn't heard of that.
 

Vincent77

Member
No, i had to find the right init or cdev but nothing about the software on internet the only software that give me some information is ramdoubler he refuse to start cause there is an accelerator board
 
Top