• Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.

Rejuvenating plastics and/or 3D printable parts ?

Melkhior

Well-known member
Hello,

Is there some known way to 'rejuvenate' the plastic from the PCI-era Power Macintoshes ? Not for look, just to make them less brittle, they seem to break when you just look at them.

Alternatively, is there some 3D-printable replacement parts or other solution available ? I'm looking at the 7500 (7600 are identical) specifically, but I guess it could be useful for all machines of this era.

TIA
 
Top