• Updated 2023-07-12: Hello, Guest! Welcome back, and be sure to check out this follow-up post about our outage a week or so ago.

QuickSilver Not Seeing All RAM (see image?)

LCARS

Well-known member
My new-to-me 2002 QuickSilver is not seeing all its RAM. I've moved the sticks around and it appears that the slot nearest to the processor isn't seeing any RAM. Does this picture look normal? Are those two metal prongs suppose to be there in a QuickSilver?

IMG_2675.jpg
 

LaPorta

Well-known member
To me, it looks like somehow the two legs of those sockets got pushed inside, and are being squashed by the RAM sticks. They are then not contacting the traces on the side of the stick. Those will either somehow have to be placed back upright (possibly VERY carefully), or the slot replaced. I'd venture to do the first option to start!
 

LCARS

Well-known member
Thank you for your quick reply, @LaPorta! That was great guidance; I agree that that seems to be the problem. To build up the image of what's happened, those legs have been bent about 90*?

How would you suggest bending them back up? Gently prying them back up and inline with the others?
 

mdeverhart

Well-known member
That’s what I’d suggest. A wooden toothpick or small plastic pick of some sort would be good. If they’ve bent that far they could be a little weak, so be gentle.
 

LCARS

Well-known member
Thanks, @mdeverhart. A little Saturday night surgery it is.

So odd that they're bent. The machine was scanner workstation for a design company and judging by the amount of dust inside, it wasn't rarely opened.
 

mdeverhart

Well-known member
looking at it again, it could be a little tricky. I think the top of the pin is supposed to fit in the channel at the back (you can see the ends of the other pins inside the little square holes). Bending and straightening the pin could be a little tough.
 

LCARS

Well-known member
Success! Yet somehow I feel uneasy about it. Its reporting 1.5GB but as you mentioned, @mdeverhart, the errant pins aren't properly in the channels as the other are from above. I took the picture before trying to get the pins in a little more.

The bent pins are not at the same height as the others. There's clearly enough of a connection to be seen and if this were a PowerBook, I'd be uneasy about the lack of 100% contact. Should I be worried in this application?

To do a proper fix I'd have to remove the connector, but I have no idea how to do that. Thoughts?


IMG_2678.JPG
 

mdeverhart

Well-known member
If it’s working, I’d say leave it. The RAM clips should hold the module in place well enough to get decent contact. Worst case, an intermittent connection could cause a crash, or maybe damage the RAM if it was a power pin. Trying to bend the pin further is just risking breaking it off, and then you’re out of luck until you can replace the connector.
 

LaPorta

Well-known member
I definitely agree with the above. If it works, and you don't mind it being like that, leave it alone. Trying to solder in a new one of those sockets would be a BIG job.
 

LCARS

Well-known member
Phew, I'm happy that leaving it alone seems like the consensus. Thank you all for your help and advice.

I have interesting upgrade plans for this machine and I'm glad that this wasn't an insurmountable issue.
 
Top