jessenator
Well-known member
I hope I'm not stepping on any toes, but I noticed there was no openly-available STL model for the Quadra 700 feet, so I made my own based on reference photos, case measurements, and original foot measurements and comparisons. See the Thingiverse description for more details and thoughts.
https://www.thingiverse.com/thing:4370611
I think the peak application for these will be a positive for rubber/silicone casting. PLA is very brittle and quite fragile at this scale. I've personally had mixed results with repeated install/removal of them on my own case. It was a factor mainly of filament manufacturer, tbh, but your mileage may vary. PLA I would consider to be "one and done" —don't plan on repeated installs/removals. The tolerances to the case molding is very tight.
ABS would be a bad idea IMO as the plastics are roughly the same strength, only the case is older, which may result in case damage. Nylon or PETG might be a different story, but I haven't attempted those yet.
https://www.thingiverse.com/thing:4370611
I think the peak application for these will be a positive for rubber/silicone casting. PLA is very brittle and quite fragile at this scale. I've personally had mixed results with repeated install/removal of them on my own case. It was a factor mainly of filament manufacturer, tbh, but your mileage may vary. PLA I would consider to be "one and done" —don't plan on repeated installs/removals. The tolerances to the case molding is very tight.
ABS would be a bad idea IMO as the plastics are roughly the same strength, only the case is older, which may result in case damage. Nylon or PETG might be a different story, but I haven't attempted those yet.
Last edited by a moderator: