j2theLj
Active member
I was wondering if someone might recognise what could be at fault here - the screen didn’t give a picture at all and so I recapped it and the inverter board.
Now it fluctuates from almost good but with a back line in the middle (as seen in the picture) to bright and useless where one can’t see anything.
I’ve adjusted brightness and contrast but it doesn’t affect the fluctuations on the screen…what is the most likely culprit here?
Now it fluctuates from almost good but with a back line in the middle (as seen in the picture) to bright and useless where one can’t see anything.
I’ve adjusted brightness and contrast but it doesn’t affect the fluctuations on the screen…what is the most likely culprit here?