Apfelklassik.de
Active member
Hello,
Interesting phenomenon. After my MDD G4 1.25 DP grilled it's CPU module, I got myself a "new" CPU module.
Installed, started ... Kernel message "No drivers for PowerMac3,6". Switched off.
Since then the chime comes and the fans run and that's it.
"No Video".
Tried everything, PMU reset etc.
What is striking - there are in fact (at least) 2 different "board numbers", although the 2x 1.25 was only installed in 2 MDD models. The RackMac did not have a 2x 1.25.
I mean, "every" 2x 1.25 board should actually know a PowerMac3,6 ...? Or?
Anyone else have any thoughts?
Interesting phenomenon. After my MDD G4 1.25 DP grilled it's CPU module, I got myself a "new" CPU module.
Installed, started ... Kernel message "No drivers for PowerMac3,6". Switched off.
Since then the chime comes and the fans run and that's it.
"No Video".
Tried everything, PMU reset etc.
What is striking - there are in fact (at least) 2 different "board numbers", although the 2x 1.25 was only installed in 2 MDD models. The RackMac did not have a 2x 1.25.
I mean, "every" 2x 1.25 board should actually know a PowerMac3,6 ...? Or?
Anyone else have any thoughts?