Iesca
Well-known member
Hi Everyone,
I recently acquired a DaynaFile with a 5.25" 360k drive in it. Due to some corrosion, I depopulated most of the controller board for cleaning and socketing, and to replace the pin headers.
Since it is (mostly) depopulated, with all the board redesigns happening (SE, SE/30, Classic, LC III...), is this something people would like a go at? I took photos with the original jumper settings prior to removing things, and I bought an EPROM programmer with the intent to dump the ROM (v3.1). The board itself is revision 2.1.
I can remove the last handful of components and do hi-res scans if someone is interested. Seems to be 4-layer.
Pic 1: Initial inspection...
Pic 2: Basic clean-up...
Pic 3: Taking a bath!
I recently acquired a DaynaFile with a 5.25" 360k drive in it. Due to some corrosion, I depopulated most of the controller board for cleaning and socketing, and to replace the pin headers.
Since it is (mostly) depopulated, with all the board redesigns happening (SE, SE/30, Classic, LC III...), is this something people would like a go at? I took photos with the original jumper settings prior to removing things, and I bought an EPROM programmer with the intent to dump the ROM (v3.1). The board itself is revision 2.1.
I can remove the last handful of components and do hi-res scans if someone is interested. Seems to be 4-layer.
Pic 1: Initial inspection...
Pic 2: Basic clean-up...
Pic 3: Taking a bath!