jimjimx
Well-known member
I recently turned on my SE/30, and as it was about to finish booting, I turned down the brightness, went too far and went all black, when I turned it back up, I saw a vertical line……
Well, I opened it up and went through the analog board, and fluxed, flowed, and filled all the joints…
Its all good again…..
Than I decided to do my 512kE, which has a "slap it on the side" problem…
Thats good again too…
But the 512 didn't have the plastic rivets. The isolation sheet was held on by double stick foam tape..
All the holes are there, but no rivets.
Where can I get those plastic rivets? I don't want foam tape.
Has anyone else seen this?
S/N says 46w "86.
--jim
Well, I opened it up and went through the analog board, and fluxed, flowed, and filled all the joints…
Its all good again…..
Than I decided to do my 512kE, which has a "slap it on the side" problem…
Thats good again too…
But the 512 didn't have the plastic rivets. The isolation sheet was held on by double stick foam tape..
All the holes are there, but no rivets.
Where can I get those plastic rivets? I don't want foam tape.
Has anyone else seen this?
S/N says 46w "86.
--jim