I decided to put a PCI SATA card inside my beige G3 and connect a SATA SSD to it, for reliability, sound levels, and above all, speed.
However, I noticed I can only get about 10MB/sec throughput. Either by duplicating on the same disk, or copying between disks.
I read the PCI bus on the...
Unsure if it came like this or if I lost a pin somehow removing it either from the foam it was embedded in or the socket when I inserted and tested it.
The pin is “TDI”. The socket is clean, the board is clean (of phantom pins) and I can’t seem to see a pin in the foam block.
Using Norton...