Me too...
Did you happen to find a solution to this?
My Classic with an AMP 2-532955-4 RAM card gives me a 00000005 / 00010001 error when booting but is fine with a regular Apple RAM card or none.
The Classic is recapped on both boards and has no other issues AFAICT.
Recapping Mac II rev B board. Board not hooked up to anything. Removing both axial batteries. The B2 pads sparked occasionally when I applied flux and the iron with or without wick to remove the battery. The battery was corroded. I got the battery off with minimal sparking thankfully.
Is this...
I've got a few of these. I've recapped 2 of them, just like 3lectr1cPPC did. 1 of them boots just fine, the other ticks (or probably turns on and off) repeatedly. I've tried to compare the 2 by checking continuity all over it and I can't find any differences. Any suggestions on what to check...
Can anyone identify where the fuse(s) is on a 5300 logic board? I can't find an F or a PF on mine for the life of me. Are there any other abbreviations that are used for fuses?
I'm doing this exact repair & my L3 broke a leg as well while I was desoldering it. Appears to be pretty common.
What should I replace it with? I'm shopping for 150uH's but what Maximum DC Current do I need? Mouser has up to 50 A.
I'm reviving a Duo 230. I've recapped it, replaced some bad diodes & the LT1171 voltage regulator (per a discussion in this forum that seems to have gotten lost in the crash last year).
The display is fine because it works with another working Duo I have.
It chimes, now that it's recapped &...
I removed the gasket from my Portable Conner CP3045, as recommended. It wasn't gooey and came off pretty easily. The drive looks pretty clean. I haven't tested it yet. Waiting to recap the Portable first and don't have the adapter to try the drive on something else yet.
What should I replace...