I think there is a way around the HDMI license by putting it into DVI mode. I think thats how the GBA Consolizer and gets around it and why not all TVs work with audio for that mod. Couple of other things out there I think are labeled that way as "Digital Video" or "Digital Out"
I saw that the clock speed and voltages on the CPU cards can be changed by changing the resistors on the board. Does anyone have experince with this? I know each chip is different, but is there a certain amount that is reliable to overclock to, say 90% of the time? I currently have the 800mhz...
I obtained a iBook G4 14" - mid 2005, and the screen is slightly dark, even at it's brightest. Do I need to replace the panel or is the backlight separate in a unit this old. Also, might as well ask, is there an adapter, or series of adapters to go from what ever connector is used for this...
Ok got the OLED attached via jumpers and it kinda works. Set height to 64 in the script and still gives mostly grabbled display any ideas from anyone here on what is going on?
I actually don't know much really, just saw that the NVMe storage worked with the I/O board and the firmware had been updated to allow booting from it. Also read that for read/write speed that PCIe 1x > USB3.0 > emmc > microSD. As for routing PCI over pci express that is way out my league.
It...
I am working on getting a RaSCSI setup for using the Raspberry PI Compute Module 4. I have the I/O board and 1GB ram CM4 Lite(no onboard EMMC). I wanted to use a 2GB or 4GB version but they are out of stock at work due to chip shortage(I am a repair tech at Microcenter). Anyway, the whole...
Actually both, I was planning on moving the heavier heatsink from a Centris 650 to a Quadra 650 with the other heatsink. I was examining also looking at using this. I was asking because even using caliper I always screw something out. You should have seen how many revsions it took me to...
I am looking for the dimensions for the bracket that holds the heatsink for a Centris 650. It is label 830-0115. I want to model and 3d print a replacement that includes a small fan mount. Googling that number didn't help. I plan to use Polycarbonate(PC) for printing so should hold up to the...