• Hello, Guest! Welcome back, and be sure to check out this post for more info about the recent service interruption and migration.

Search results

  1. B

    NuBusFPGA: HDMI on NuBus Macs

    To match it, you’d have to use a PDS card instead of NuBus…
  2. B

    NuBusFPGA: HDMI on NuBus Macs

    I'm pretty sure that's only if you sell it; and mark it with the registered trademarks. However - I am not a lawyer, nor do I play one on TV, etc, etc... But in this case; it's most definitely NOT an HDMI connection - that would require adherence to HDCP, etc - it's just a DVI signal being sent...
  3. B

    Term for Mac Plus and Earlier Keyboard Connector?

    There wasn't. It's just the 128k/512k/512ke/Plus keyboard and mouse connectors.
  4. B

    NuBusFPGA: HDMI on NuBus Macs

    FWIW, on my other machine (2015 i7 iMac) I've got a linux-based VM that runs Xilinx ISE... although I haven't tested programming an XC9500 series chip with it yet. It's based off of the VM that Xilinx was distributing for running ISE under Windows 10. IIRC, it runs in VirtualBox.
  5. B

    Daystar Genesis MP

    I remember being at Macworld when these first came out, seeing it run - and really wanting one badly, but knowing that there was no way I was going to be able to get the budget for that. IIRC, the initial multiprocessing services manager that Apple shipped with the OS was licensed from Daystar...
  6. B

    Idea: Arduino style board for hacking the PDS slot?

    OK, I'm back and have had a chance to read the thread. It looks like it's not quite as bad as I had thought; however I'd still use a CPLD to manage the low-level bus interface - it's just not that hard of a thing to integrate, compared to what it gives you. From Designing Cards and Drivers...
  7. B

    Idea: Arduino style board for hacking the PDS slot?

    I haven't had a chance to fully read the thread since I made the post - and I'm on my way out the door right now - so I'll have more to say about it later; but... I am making the presumption that the MCU will service interrupts other than the bus interface interrupt; which will totally kill any...
  8. B

    Idea: Arduino style board for hacking the PDS slot?

    A Microcontroller won't have the performance needed for a direct CPU-bus interface. You'll need to use a CPLD and some discrete logic at a minimum; but adding a FPGA to the mix would really help matters. The XC9500 series CPLD is 5V tolerant but runs at 3.3v; and is available in QFP packaging...
  9. B

    A/B and Flyback issue futureproofing from the other side of the Looking Glass?

    What I had in mind was to completely replace all of the circuits on the Analog Board - HV drive for the CRT's anode & cathode; sweep, blanking, etc. What I'm looking for datasheet-wise is something that gives a) the pinouts of the CRT; and b) the voltages and currents required.
  10. B

    A/B and Flyback issue futureproofing from the other side of the Looking Glass?

    No, I don't - hence the question. I'm wondering if the old Sam's Photofact sets might have something in it?
  11. B

    Development of Nubus graphics card outputting to HDMI?

    The other possibility is to cut the resolution in half in both directions 1920x1080 becomes 960x540; and just have the FPGA do the pixel doubling so the 68k processor only sees the lower resolution.
  12. B

    A/B and Flyback issue futureproofing from the other side of the Looking Glass?

    If we could find the data sheets for the CRTs themselves, we could design a driver board that uses all modern general purpose parts - a microcontroller to generate the requisite waveforms; voltage multipliers to drive the high voltage for the tube itself, etc…
  13. B

    5.25 Drive in Powermac

    In principle, a board could be designed to interface a PC 5.25 drive to SCSI - perhaps based off the BlueSCSI project. You'd then have to write a driver for the Mac to read it. AdaFruit has recently done some work interfacing floppy drives to their CircuitPython boards... so resources are out...
  14. B

    Idea: Macintosh Classic III (LC550+M1420)

    Uhh... shouldn't the frame rate be tied to the 60hz vertical blanking interrupt?
  15. B

    Snatched a Quicksilver. Unsure why.

    Hey - at least you don't have wildlife jumping out in front of you while you're driving back from said storage units!
  16. B

    Snatched a Quicksilver. Unsure why.

    Slap some PV panels on your roof and quit worrying about it. ;) (seriously - the emissions from just changing your driving style a little bit absolutely dwarf what a computer uses. 1 Horsepower = 0.7457 kW)
  17. B

    Snatched a Quicksilver. Unsure why.

    What to use it for? Marathon, of course!
  18. B

    Help getting started with retro software development

    It is a hard-learned truth that the fewer lines of code you have, the better off you are: that's code that you don't have to maintain... and that applies to everything from tiny microcontrollers to classic computers to large systems running on modern hardware. So, yeah - prune it down to the...
  19. B

    TashTalk: Single-Chip LocalTalk Interface

    I sprung the $$$ for the compiling service at www.gryphel.com... I can only presume whatever warnings the complier may be throwing are getting tossed into /dev/null....
  20. B

    Original BMUG Disks

    I've found that sometimes 70% isopropyl won't work for some stuff - I have to use 99%; because what the other 30% is made of in 70% isopropyl is water; and some stuff is very hydrophobic.
Top