• Hello, Guest! Welcome back, and be sure to check out this post for more info about the recent service interruption and migration.

Recent content by robin-fo

  1. R

    SE/30 Screen Artefacts

    Thanks @Bolle; du you have a suggestion which model number I could try and where to look for it?
  2. R

    SE/30 Screen Artefacts

    I was even able to make screenshots of it.. What is going on here?? The ClarisWorks canvas on the third picture mostly stayed normal...
  3. R

    SE/30 Screen Artefacts

    Hi everbody After running for some minutes, some serious pixel errors appear on my SE/30‘s internal screen. The logic board is a replica with all-new passives, the AB is not yet recapped. Snooper doesn‘t appear to find any RAM errors but the DIP PALs get quite hot (ca. 50° C). Interestingly...
  4. R

    VGA Studio Display 15" – White Screen

    This is how it looks inside
  5. R

    VGA Studio Display 15" – White Screen

    There are two plastic latches next to the apple logo. Release the bezel as much as possible and pry from above with a flathead screwdriver. It is tricky, though…
  6. R

    VGA Studio Display 15" – White Screen

    I managed to open it in last August, but I remember that it was rather tricky. Do you know where I can find the model number, except on the inside?
  7. R

    VGA Studio Display 15" – White Screen

    Hi everybody, I have a beautiful blue and white Apple Studio Display with VGA connector. After not using it for about one or two years and storing it in a slightly damp (not wet) room for some of that time, it refuses to work. When I power it up, it only shows a white (or bright gray) screen (...
  8. R

    Macintosh SE/30 logicboard recreation (thread revival)

    That's great news! Well done!
  9. R

    will this sata card be botable in a rev2 G3? BW

    I can confirm it works down to System 7.5.2
  10. R

    will this sata card be botable in a rev2 G3? BW

    I‘m using exactly the same successfully in my WGS 8550. It is very fast and doesn‘t need any drivers. And yes, it‘s bootable! 😃
  11. R

    Macintosh SE/30 logicboard recreation (thread revival)

    During the absence of a working RTC chip, I had a similar scenario with the Rominator installed: Boot chime and shortly after that a sad mac screen with death chime. With the original ROM installed however, it booted straight to the blinking question mark (but not further due to the absence of...
  12. R

    (PPC) Routing software

    Many thanks!!
  13. R

    (PPC) Routing software

    Thanks guys, however I still haven't found what I was looking for: An AppleTalk routing software compatible with OpenTransport...
  14. R

    Macintosh SE/30 logicboard recreation (thread revival)

    Had the same problem. It turned out that the RAM itself was the issue.
  15. R

    NuBusFPGA: HDMI on NuBus Macs

    Fantastic!
Top