Thanks. The screen is perfectly readable. A bit small, but nothing that I have to strain to see.
I did not know about the overclocking mod? Any sources for that?
I finished my Mystic mod last night and installed my LC575 board into my CC. Went really well. I used a hobby knife to cut the traces, first scoring them with the blade and then turning it over to the dull side and scraping the copper trace away through the score marks.
So far it is very...
I have done this same thing with a printer and it worked pretty well. Eventually, the heat from the printer caused it to dislodge. Anyhow, I am going to issue a refund to my buyer so all is well here. I don't need to fix this board.
Thanks for the advice either way.
Thanks for the tips. I have been on these sites already but I am not seeing what I need. I have a CC board that has the pads destroyed on C4 and C5 is iffy. I would like to know where to connect a jumper wire from the cap to the destination of the trace.
I cannot seem to find a schematic of the...
Can someone please tell me where C4 and C5 connect to on the main board?
I repaired one back in the summer. It had a few weak pads on C4, but I was able to get them to stick. It has worked and been 100% stable for the last 6 months.
I traded it to a friend in Singapore and shipped it to him...
That is a sweet machine. It looks super clean. Good job on the rescue.
I have a blog where I wrote about how to build a serial to Ethernet bridge using a serial cable, USB adapter and a Raspberry Pi. No Ethernet Card is required in the Classic Mac at all.
You can see my article...
I see there are quite a few on ebay. Although I think you can use a 12v 1.5A power supply and a 7 pin DIN plug. There is a great thread on Applefritter about this here: https://www.applefritter.com/content/apple-iic-power-adapter
(not my thread, and I have not built one of my own, so "great"...