I'm still trying to find the problem with my Color Classic analog board which I smoked a few days ago. I get no +5 or +12 volts, nor am I producing 22KV to the CRT. While looking for bad components I found what looks like a burned resistor. I remove it and it measured 0.11ohms. What's...
After smoking my CC analog board, I have no +12- or +5-volt outputs to the logic board. Diagnosing the problem is proving to be a good learning experience. Please correct me if I’m wrong, but it looks like the CC’s analog board uses a 4A full-wave bridge rectifier (DP1) on 60Hz AC line voltage...
I made some progress on my Color Classic. I was able to pick away the glue that was preventing me from adjusting the trimpot. I was then able to adjust it to get B+ to 71.0V. The resistances between the pot pins were 372, 372, and 0 ohms (previously the measurements were 517, 517, and 0 ohms)...
The pot is turned to its limit as you say. I assumed counterclockwise (0 ohms) since B+ is only 68.5V. If I turn the pot clockwise (higher resistance), B+ should rise. Am I wrong on that?
I found a YouTube video that Techknight produced while trouble shooting a CC analog board. He showed how to adjust the B+ voltage level to control the CRT's high voltage. He said that B+ should be about 71 volts to produce ~22,000V at the CRT anode. B+ on my board was only 68.5V which could...
I reduced the horizontal width with only a slight improvement of the raster shape. Does anyone happen to know the correct B+ voltage for the Color Classic and which pot controls it?
Try as I might, I haven't been able to produce a nice clean rectangular raster shape. The upper right corner appears shrunken. Any hints would be appreciated.
It's not perfect, but I was able to improve the geometry of the CC's raster. It's all accomplished using the 7 right most potentiometers on the back of the analog board (once the yoke is adjusted to level the picture). The rings on the yoke are used for vertical convergence adjustment while...